Salary Cap Leagues, Allocating Cap for Your WR3 and WR4

Footballguys Staff's Salary Cap Leagues, Allocating Cap for Your WR3 and WR4 Footballguys Staff Published 08/08/2023

See our prior thoughts on the wide receiver position:
Should You Target the Big 2 WRs?
How Much Cap for Your Starting WRs?

It is pretty clear that drafters are going to emphasize the wide receiver position this year over most other options. We have scratched the surface of wide receiver strategy, so let's dig a little deeper and start to fill out the position. We'll do this with a couple of questions.

Dig Deeper: See our salary cap values here >>>

Note: All answers assume the following criteria:

  • Start 1 QB, 2 RBs, 3 WRs, 1 TE
  • 4-point passing TDs
  • Full PPR
  • $200 cap
  • 12 teams

For your WR3, where is your cutoff for an acceptable final starter? Our salary cap values have a tier break around WR34. The next tier goes down to WR54. How low will you go to get that final starting wide receiver?

Ben Cummins: I’m comfortable going all the way to a Skyy Moore/Jakobi Meyers/Tyler Boyd type if it means I was able to land at least one elite wide receiver.

Jason Wood: Ideally, I'm coming away with three receivers in the Top 27. Drake London (WR27 in our values) is my cutoff for starters. I'm excited to roster and see little risk of disappointment, barring injury. If the plan falls through, I'll ensure I have my third and fourth receivers by the point we're at WR36.

Andrew Davenport: I don't even want to go as low as Moore at WR31. I prefer to get three guys from roughly the Top 20 wide receivers. That's not a hard and fast rule, and I'll adjust on the fly, but I'm absolutely aiming to, at minimum, have a guy like Christian Kirk or Deebo Samuel be my WR3 in order to give my roster the pop I want it to have.

Jeff Bell: My Plan A is to add two of the top tiers of wide receivers along with a Hero RB as the backbone of my team. Executing that means you are scrounging a bit at RB2 and WR3, targeting high upside depth pieces at a value. Missing on that tier for WR2 opens up to add more. Ideally, adding three players in the WR2-WR3 tier to ensure injuries or byes are covered is the preferred method, creating more production in aggregate by avoiding weak points.

Do you try to fill your flex with a wide receiver? If so, how much will you spend for your flex wide receiver?

Already a subscriber?

Continue reading this content with a ELITE subscription.

An ELITE subscription is required to access content for Salary Cap leagues. If this league is not a Salary Cap league, you can edit your leagues here.

Photos provided by Imagn Images
Share This Article

More by Footballguys Staff

 

Everything Season Long and DFS for the Conference Championships

Your landing page for all of our weekly fantasy football content.

01/24/26 Read More
 

What We Learned Last Season: Quarterbacks

Sigmund Bloom

A look back at the 2025 season for fantasy football quarterbacks and what we can learn from it.

01/27/26 Read More
 

Injury Roundup from Conference Championships

Adam Hutchison

A Monday morning recap of the fantasy-football-relevant injuries from last week's NFL games.

01/26/26 Read More
 

2026 Fantasy Football 1st Round (Way-Too-Early)

Dave Kluge

Dave Kluge and Andrew Cooper of Fantasy Alarm draft their top players for 2026 fantasy football drafts in a new episode of Footballguys' The Launch Pad.

01/26/26 Read More
 

FanDuel Percent Rostered Week 21

Devin Knotts

Breakdown of Percent Rostered for Conference Championship Week

01/24/26 Read More
 

DraftKings Percent Rostered Week 21

Devin Knotts

Breakdown of Percent Rostered for Conference Championship Week

01/24/26 Read More