Note: This series is designed to take auction drafters of any ability and refine their auction skills to those of a seasoned auction veteran. The articles will go from very simple concepts all the way to the most advanced auction theories. Each article is designed to build on the previous articles in the series. For best results read each article before proceeding to the concepts in the next article. For a breakdown of auction mechanics and strategies see Footballguy Jeff Pasquino’s excellent 8-part Auction Primer Series.
Other sections of this series:
- Part 2: Attacking Beginner Auctions
- Part 3: Beginner Preparation
- Part 4: Nomination Strategies
- Part 5: Bidding Strategies
- Part 6: Reading Your League
- Part 7: Inflection Points
So your league has decided to give auction drafting a try. It may seem daunting at first, and it’s natural to have some anxiety about it, but by following some simple guidelines you can already be ahead of your league before you get there. Drafting in an auction format is at once both exciting and stressful. It requires a level of attention that serpentine drafting does not. As a result, you will literally make hundreds of micro-decisions throughout the draft that ultimately lead to the players you end up with. But before you can excel at all of those decisions and run away with the best team, you have to learn to walk first. And if you’re here that means you’re just learning to walk. The best way to do that is to avoid some common beginner mistakes.
Beginner Mistake #1 – Leaving Money Behind
This is not a difficult concept intrinsically, but in practice, it is very hard. Chances are good, that in any article on auction drafting you have ever read, this concept is one that you will see. In fact, the Auction Primer series covers this very same thought. Why is that? Because it is THAT important. Too often novice drafters end up with extra money (for a variety of reasons that will be covered down the road), and that leads to frivolous spending on defenses or throwing the last money at the RB55 because that’s all that’s left. Again, the concept is simple – spend your money! – but for practical purposes walking the fine line between blowing your money too early and not spending it all is a tough one to navigate. This series will give you those tools, but for now, just remember to try not to leave the draft with any money. If you find yourself at the end of the draft with too much money and all that is left is the RB40 and a couple of wide receiver flyers, don’t scoff at them and think “these guys aren’t worth this money”. Instead, spend the money and take them anyway. Last year a quarterback by the name of Lamar Jackson was a player with a very low price tag and he turned in to a league winner for many teams. Rather than beating yourself up, go grab the best that’s available and hope that one of them pans out. They won’t all be Lamar Jackson, but there are plenty of cheap players that turn out to be valuable producers. Using your remaining cap on as many of them as you can is the single biggest lesson to learn before your auction.
Beginner Mistake #2 – Eliminating yourself early
It doesn’t matter if an owner is new or experienced, first auction or 51st, there will always be someone that takes themselves out of the auction early because they spend all their money in the first few rounds. This idea is a beginner concept, but the fact is that the most-veteran of drafters can still fall prey to this pitfall. If you eliminate this possibility with careful planning and self-control you can be better than 10% of drafters right out of the gate. Also, this idea is not mutually exclusive with the thoughts laid out above. In fact, these two concepts have a direct relationship. Your job is to spend all of your money but to do it in a manner that leaves you flexible at the various key points in the draft. These points can occur 4 to 6 times during the draft and they are known as “Inflection Points.” You must massage your budget as the draft moves along to secure top talent, not take yourself out of the draft, and leave yourself maximum flexibility when these various Inflection Points hit. (Stay tuned in the series for a detailed discussion of Inflection Points and how to take advantage of them)
Beginner Mistake #3 – Failing to Secure Elite Talent
This is often a function of each particular owner and their penchant for risk-taking. Some people have it in their personality to spend wildly and get lots of top talent and some don’t have the stomach for that. That is, of course, what makes auctions so much fun. In a serpentine draft, you get one first-round pick. In an auction, you can spend enough to have several first-round picks. But the mistake comes when an owner gets uncomfortable every time the bidding gets high enough that it represents a large part of their budget and they don’t end up with any first or second-round picks. They drop out because they didn’t have enough money allocated, or they didn’t have the fortitude to keep bidding in a pressure-packed moment where 20-30% of their budget is in play. In this scenario, the bidding will surpass an owner’s number they had earmarked for a particular position and rather than recognizing the moment they fold instead of continuing to bid. This most often happens when there is a bidding frenzy for the top talent near the beginning of the draft. While auction strategy dictates that if players are way overpriced eventually the deals will come, you simply can’t afford to wait while the top talent flies off the board. If you wait and refuse to “overpay” you will leave the draft with plenty of solid players but nobody elite. If you translate that from auction to serpentine terms it would be like leaving the draft with multiple third- through fifth-round picks and no first or second-rounders. Would you trade your first and second-rounders for two thirds and a fourth? Of course not, so guard against this in an auction. You will almost never regret throwing a few extra dollars at elite talent, but you will certainly regret stopping and then realizing that the top guy on the board is the WR21. Make sure you leave the draft with some first and second-round picks and not a glut of mid-round players.
Beginner Mistake #4 – Lack of Preparation
Doing an auction draft requires an altogether different level of preparation than a conventional draft. Printing out a cheat sheet or looking at some rankings on a phone may be an easy and even somewhat reasonable way to pick players in a serpentine, but that is not the case in an auction if you want to succeed. The auction forces you to form an opinion on *every single player* that will be available during the course of the draft. Why? Because you don’t know when players will be nominated. There is no 20-minute wait for you to narrow down your pick or do some quick research as you sit and wait for picks to be made ahead of you. When a player is nominated it can often be when you aren’t expecting it and you must be able to react. If you need a running back and someone says Melvin Gordon then you have to know exactly what to do at that moment. When the bidding stops at $19 and that seems too low to you, you won’t have minutes to ponder your move, you’ll have mere seconds. So the answers to the following questions must already be answered: What is Melvin Gordon worth? Do I care if he goes cheap, in other words, do I even want him on my team at all? Do I like him more than similarly ranked players like James Conner and Devin Singletary? If you don’t have an opinion on Gordon, and also Conner and Singletary, you won’t make a good decision in the heat of the moment. The key to not losing your head when faced with those calls during a draft is preparation, preparation, preparation.
Beginner Mistake #5 – Poor Record Keeping
One of the single biggest ways you can gain an edge in auction drafting is keeping good records during the draft. Simply crossing names off the list as they’re drafted is not enough anymore. It’s rare to have a display of the entire league’s cap situation provided for you as the draft progresses so you should plan on doing it yourself. The best way to do that is to have some software that allows you to input prices as you go to keep track of what each team has left to spend. Footballguys has its own answer to this issue, and that is the Draft Dominator. It is a fantastic piece of software that keeps track of every single thing you need to know during your draft including remaining cap space, maximum bid allowed, estimated auction values for remaining players, and individual roster construction. All of these things make you vastly more capable of understanding who will bid, how much they want the player, and whether they can afford to be involved after a certain price point.
However, while the Draft Dominator is great, the recommendation here is quite simple: keep track of as much as you can while the draft is happening. You can do this by hand, a simple excel spreadsheet, or using the powerful Dominator. But the absolute minimum for a beginner is to keep meticulous track of your own situation. You should know to the exact dollar, not an estimate, what you can spend at any point in time. If you are not keeping good track of your situation it will trip you up at some point. Doing this by hand is fine, but if you want to keep track of the whole league (which you absolutely have to do at some point to progress as an auction drafter) it is smart to use some kind of software to track everything. It makes your draft much more manageable, especially when you’re just starting out. And as you’ll see as this series progresses, pulling off some of the more advanced moves requires constant omnipotence over the league’s various cap situations.
So now you have some ideas about some basic things that trip up beginners as they are starting out. None of these thoughts are particularly novel or advanced, but they are absolutely essential to master as the bedrock of a more polished auction skillset. Next up, Part 2: Attacking Beginner Auctions.
For more on Auction Drafts and strategies visit the author's short video series, The Auction Brief, found here:
The Auction Brief - Episode 2: Control What You Control
For more from this author check out his other pieces found here.
Follow @DrewFBGAuctions